The U.S. Environmental Protection Agency (EPA) has reached an agreement with two Southern California plastic product manufacturers to resolve federal Clean Water Act violations. Both companies have corrected the deficiencies and have returned to compliance.
In December 2015, EPA inspections at the two facilities found violations that likely resulted in plastic pellets, known as “nurdles,” entering storm drains that discharge to the Tujunga Wash, which flows into the Los Angeles River. Nurdles are plastic beads about one fifth of an inch in diameter. They are widely used in manufacturing and contribute to plastic debris in the nation’s inland and coastal waters.
“The Los Angeles River provides vital habitat to birds, fish and other organisms that depend on the river for survival,” said Alexis Strauss, EPA’s acting regional administrator for the Pacific Southwest. “It is essential that manufacturers take proper steps to prevent nurdles from polluting surrounding waterways and harming local wildlife.”
EPA inspected the facilities in support of the state’s environmental justice enforcement initiative in the Pacoima/Sun Valley neighborhoods in the city of Los Angeles.
Western States Packaging, located in Pacoima, California, uses nurdles as raw material to manufacture food grade plastic bags. EPA’s inspectors found that the facility was not operating with the proper stormwater permit. Additionally, EPA observed spilled plastic pellets on paved surfaces throughout the facility without proper control measures in place.
Under this agreement, Western States Packaging, Inc. will pay a $25,000 penalty and Direct Pack, Inc. will pay a $42,900 penalty.
Direct Pack, located in Sun Valley, Calif., uses nurdles to manufacture plastic packaging products. EPA inspectors discovered the facility was discharging industrial wastewater without the proper permit. The inspection also found that the facility did not use proper capture devices, such as pans or tarps in loading areas, and did not have necessary containment systems to trap plastic material and prevent releases to local waterways. Additional deficiencies included improper storage of chemicals and industrial wastes. Finally, the company failed to promptly repair or maintain equipment and did not accurately report monthly inspections.
Under the Clean Water Act, plastic manufacturers are required to obtain a stormwater permit from the state to discharge industrial stormwater to surface waters. The permit requires the installation of controls and use of best management practices to prevent or minimize the discharges of pollutants in runoff from their operations. Such discharges may contain pollutants such as plastic resin pellets, flakes or powders.
Published in the August 2017 Edition of American Recycler News